Installation [12/2013 - ]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Refer to INITIALIZATION [12/2013 - ]

1. Install a new gasket to the engine coolant temperature sensor.
2. Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the cylinder head sub-assembly.

   Torque: 19.6 N*m (200 kgf*cm, 14 ft.*lbf) 

   NOTE:

   • If the engine coolant temperature sensor has been struck or dropped, replace it.
   • Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

     Refer to PRECAUTION [12/2013 - 11/2016] , or refer to PRECAUTION [11/2016 - ]

3. Connect the engine coolant temperature sensor connector.
4. Install the heater bracket to the cylinder head sub-assembly with the bolt.

   Torque: 12.5 N*m (127 kgf*cm, 9 ft.*lbf) 

5. Engage the heater hose to the heater bracket.

See step  4 , or see step  4

Refer to PROCEDURE - Step 2 , or refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 67 , or refer to PROCEDURE - Step 67

1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

   Refer to INITIALIZATION [12/2013 - ]