Installation [11/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
- Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the crankshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
- Connect the crankshaft position sensor connector.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 5
- INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 76 , or refer to PROCEDURE - Step 76