Installation [12/2013 - 11/2015]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
- Apply adhesive to 2 or 3 threads of the bolt for the camshaft position sensor.
*a Adhesive Adhesive
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
- Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
*a O-ring - Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the camshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or does not move out of place during installation.
- Connect the camshaft position sensor connector.
- Apply adhesive to 2 or 3 threads of the bolt for the camshaft position sensor.
- INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
- Apply adhesive to 2 or 3 threads of the bolt for the camshaft position sensor.
*a Adhesive Adhesive
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
- Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
*a O-ring - Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the camshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or does not move out of place during installation.
- Connect the camshaft position sensor connector.
- Apply adhesive to 2 or 3 threads of the bolt for the camshaft position sensor.
- INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 5
- INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 67