LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (1AR-FE) (Service Information) (Except Hybrid)) >> Camshaft Position Sensor >> Installation [11/2015 - ] >> Procedure

Installation [11/2015 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side) 
    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
    2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • If the camshaft position sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
    3. Connect the camshaft position sensor connector.
  2. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side) 
    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
    2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • If the camshaft position sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
    3. Connect the camshaft position sensor connector.
  3. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 5

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 67 , or refer to PROCEDURE - Step 67

scientia non olet · About LEMON Manuals