Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY
NOTE:
- Avoid physical shock to the accelerator pedal sensor assembly.
- Do not disassemble the accelerator pedal sensor assembly.
- The accelerator pedal sensor assembly does not require lubrication.
- Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
1. Install the accelerator pedal sensor assembly with the 2 nuts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  NOTE:
  If the accelerator pedal sensor assembly has been struck or dropped, replace it.
2. Connect the accelerator pedal sensor assembly connector.