LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Starting System (1AR-FE) (Service Information) (Except Hybrid)) >> Ignition Switch >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY 
    1. Check the resistance.
      GTY434069Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Ignition or Starter Switch Assembly)
      *b LOCK
      *c ACC
      *d ON
      *e START
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        Between all terminals LOCK 1 MΩ or higher
        5 (AM1) - 7 (ACC) ACC Below 1 Ω
        5 (AM1) - 7 (ACC) - 8 (IG1) ON Below 1 Ω
        3 (IG2) - 4 (AM2)
        5 (AM1) - 6 (ST1) - 8 (IG1) START Below 1 Ω
        2 (ST2) - 3 (IG2) - 4 (AM2)

        If the result is not as specified, replace the ignition or starter switch assembly.

scientia non olet · About LEMON Manuals