LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Fuel System (1AR-FE) (Service Information) (Except Hybrid)) >> Fuel Sender Gauge Assembly >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT FUEL SENDER GAUGE ASSEMBLY 
    1. Check that the float moves smoothly between F and E.
    2. Inspect the fuel sender gauge assembly resistance.
      GTY428735Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Fuel Sender Gauge Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Float Level Specified Condition
        1 - 2 F 13.5 to 16.5 Ω
        Between F and E 13.5 to 414.5 Ω (Gradually changes)
        E 405.5 to 414.5 Ω

        If the result is not as specified, replace the fuel sender gauge assembly.

scientia non olet · About LEMON Manuals