LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Fuel System (1AR-FE) (Service Information) (Except Hybrid)) >> Fuel Pump >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT FUEL PUMP 
    1. Check the resistance.
      GTY438114Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 0.2 to 3.0 Ω

        If the result is not as specified, replace the fuel pump.

    2. Check the operation.
      1. Apply battery voltage to both terminals. Check that the fuel pump operates.
        NOTE:
        • Perform this test within 10 seconds to prevent the coil from burning out.
        • Keep the fuel pump as far away from the battery as possible.
        • Always switch the voltage on and off at the battery side, not the fuel pump side.

        If the fuel pump does not operate, replace the fuel pump.

scientia non olet · About LEMON Manuals