LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Fuel System (1AR-FE) (Service Information) (Except Hybrid)) >> Fuel Pressure Regulator >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to REMOVAL [12/2013 - ] 

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY 

    See step  1

  3. REMOVE FUEL PUMP 

    See step  2

  4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY 
    1. Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly from the fuel filter.
      NOTE:

      Slowly pull out the fuel pressure regulator assembly because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel filter.

      GTY437455Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 O-rings from the fuel pressure regulator assembly.
      GTY429371Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 O-ring
scientia non olet · About LEMON Manuals