LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Intake / Exhaust System (1AR-FE) (Service Information) (Except Hybrid)) >> Vacuum Switching Valve (For ACIS) >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY 

    Refer to REMOVAL [12/2013 - ]

  2. SEPARATE NO. 2 HOSE CLAMP BRACKET 

    Refer to PROCEDURE - Step 2

  3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4 , or refer to PROCEDURE - Step 4 , or refer to PROCEDURE - Step 4

  4. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) 
    1. Disconnect the union to vacuum tube hose from the vacuum hose clamp.
      GTY454983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the wire harness clamp.
    3. Disconnect the 2 vacuum hoses.
    4. Disconnect the vacuum switching valve assembly (for ACIS) connector.
    5. Remove the bolt and vacuum switching valve assembly (for ACIS) from the intake manifold.
    6. Remove the bolt and vacuum hose clamp.
      GTY444981Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals