LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Battery / Charging System (1AR-FE) (Service Information) (Except Hybrid)) >> Generator >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Refer to PRECAUTION [12/2013 - 11/2016] Refer to PRECAUTION [11/2016 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016] Refer to INITIALIZATION [11/2016 - ]

  3. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [12/2013 - ]

  4. REMOVE GENERATOR ASSEMBLY 
    1. Open the terminal cap.
      GTY444041Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the nut and disconnect the wire harness from terminal B.
    3. Disconnect the generator assembly connector.
    4. Remove the bolt and wire harness clamp bracket from the generator assembly.
    5. Remove the 2 bolts and generator assembly.
      GTY444065Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals