LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Battery / Charging System (1AR-FE) (Service Information) (Except Hybrid)) >> Generator >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL GENERATOR ASSEMBLY 
    1. Install the generator assembly with the 2 bolts.

      Torque: 52 N*m (530 kgf*cm, 38 ft.*lbf) 

    2. Install the wire harness clamp bracket with the bolt.

      Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) 

    3. Connect the generator assembly connector.
    4. Connect the wire harness to terminal B and install the nut.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    5. Close the terminal cap.
  2. INSTALL V-RIBBED BELT 

    Refer to INSTALLATION [12/2013 - ]

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016] Refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals