LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Fuel System (2GR-FE) (Service Information) (Except Hybrid)) >> Fuel Sender Gauge Assembly >> Inspection [12/2013 - 11/2016] >> Procedure

Inspection [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FUEL SENDER GAUGE ASSEMBLY 
    1. Check that the float moves smoothly between F and E.
    2. Inspect the fuel sender gauge assembly resistance.
      GTY428735Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Fuel Sender Gauge Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Float Level Specified Condition
        1 - 2 F 13.5 to 16.5 Ω
        Between F and E 13.5 to 414.5 Ω (Gradually changes)
        E 405.5 to 414.5 Ω

        If the result is not as specified, replace the fuel sender gauge assembly.

scientia non olet · About LEMON Manuals