LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Fuel System (2GR-FE) (Service Information) (Except Hybrid)) >> Fuel Pump >> Inspection [12/2013 - 11/2016] >> Procedure

Inspection [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FUEL PUMP 
    1. Check the resistance.
      GTY438433Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 0.2 to 3.0 Ω

        If the result is not as specified, replace the fuel pump.

    2. Check the operation.
      1. Apply battery voltage to both terminals. Check that the fuel pump operates.
        NOTE:
        • Perform this test within 10 seconds to prevent the coil from burning out.
        • Keep the fuel pump as far away from the battery as possible.
        • Always switch the voltage on and off at the battery side, not the fuel pump side.

        If the fuel pump does not operate, replace the fuel pump.

scientia non olet · About LEMON Manuals