Removal [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE AIR FUEL RATIO SENSOR (for Bank 2)
- Disengage the wire harness clamp.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disconnect the air fuel ratio sensor connector.
- Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly LH.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
NOTE:
If the air fuel ratio sensor has been struck or dropped, replace it.
- REMOVE MANIFOLD STAY
Refer to PROCEDURE - Step 6
- REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 7
- REMOVE AIR FUEL RATIO SENSOR (for Bank 1)
- Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly RH.
NOTE:
If the air fuel ratio sensor has been struck or dropped, replace it.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|