LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Lubrication System (2GR-FE) (Service Information) (Except Hybrid)) >> Oil Pressure Switch >> Inspection [12/2013 - 11/2016] >> Procedure

Inspection [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the engine oil pressure switch assembly connector.
    2. Start the engine.
    3. Measure the continuity of the engine oil pressure switch assembly.
      GTY147711Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Continuity

      Tester Connection Condition Specified Condition
      1 - Switch body Idling No Continuity
      1 - Switch body Engine stopped Continuity

      If the result is not as specified, replace the engine oil pressure switch assembly.

    4. Connect the engine oil pressure switch assembly connector.
scientia non olet · About LEMON Manuals