LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Automatic Transmission (U660E) - Service Information (1 Of 2)) >> Transmission Control Cable >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 1

  2. REMOVE RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 2

  3. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

  4. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 26

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 3

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 28

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 29

  8. REMOVE AIR CONDITIONING UNIT ASSEMBLY 

    Refer to REMOVAL [12/2013 - 11/2016]

  9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Separate the end of the transmission control cable assembly from the transmission floor shift assembly.
      GTY448162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, separate the transmission control cable assembly from the transmission floor shift assembly.
      GTY436798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Counterclockwise
    4. Disengage the wire harness clamp.
      GTY431161Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the nut from the transmission control shaft lever.
      GTY423470Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with the clip from the No. 1 transmission control cable bracket.
      GTY449978Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.
      GTY444212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Disconnect the transmission control cable assembly from the No. 3 transmission control cable bracket.
      GTY448143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Turn back the dash panel insulator.
      GTY438334Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Remove the 3 bolts and pull out the transmission control cable assembly from the cabin.
scientia non olet · About LEMON Manuals