Inspection [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position.
*a Component without harness connected
(Park/Neutral Position Switch Assembly)Standard Resistance
Tester Connection Shift Lever Position Specified Condition 1 (RB) - 3 (PL)
4 (B) - 9 (L)P Below 1 Ω Except P 10 kΩ or higher 1 (RB) - 2 (RL) R Below 1 Ω Except R 10 kΩ or higher 1 (RB) - 8 (NL)
4 (B) - 9 (L)N Below 1 Ω Except N 10 kΩ or higher 1 (RB) - 7 (DL) D, S, "+" or "-" Below 1 Ω Except D, S, "+" and "-" 10 kΩ or higher If the result is not as specified, replace the park/neutral position switch assembly.
- Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position.