LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Automatic Transmission (U660E) - Service Information (1 Of 2)) >> Park / Neutral Position Switch >> Adjustment [12/2013 - 11/2016] >> Procedure

Adjustment [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Remove the transmission control shaft lever.

      Refer to REMOVAL [12/2013 - 11/2016] 

    2. Loosen the 2 bolts of the park/neutral position switch assembly.
      GTY431168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Align the protrusions of the park/neutral position switch assembly.
      GTY429640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protrusion
    4. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.
      GTY431168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      NOTE:

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.

    5. Install the transmission control shaft lever.

      Refer to INSTALLATION [12/2013 - 11/2016] 

    6. After the adjustment, perform the park/neutral position switch assembly operation check.

      See step  1

scientia non olet · About LEMON Manuals