DTC P0503: Vehicle Speed Sensor "A" Intermittent / Erratic / High [12/2013 - 11/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
5. Check for DTCs.

   Chassis > ABS/VSC/TRAC > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

6. Turn the engine switch off.

Result:  2

B 

GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART). Refer to  DIAGNOSTIC TROUBLE CODE CHART [12/2013 - 11/2016] 

Result:  1

A 

See step  2

1. Replace the combination meter assembly.

   Refer to REMOVAL [12/2013 - ]

Result: 

NEXT 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - 11/2016]

4. Perform the following to make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the malfunction cannot be detected.

   1. Drive the vehicle at a speed for which cruise control operation is possible.
   2. Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
   3. Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.
5. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
6. Check for DTCs.

   Powertrain > Radar Cruise > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P0503 is output	B

7. Turn the engine switch off.

Result:  1

A 

END 

Result:  2

B 

REPLACE ECM. Refer to  COMPONENTS [12/2013 - 11/2016]