Cruise SET Indicator Light Circuit [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY 1)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the cruise control SET indicator by performing the Active Test.
Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Meter Display 1 Cruise control SET indicator OFF or All - Body Electrical > Combination Meter > Active Test
Tester Display Meter Display 1 OK
The cruise control SET indicator light goes on or off.
Result
Proceed to OK NG - Turn the engine switch off.
Result: 1
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [12/2013 - 11/2016]
Result: 2
NG
REPLACE COMBINATION METER ASSEMBLY. Refer to COMPONENTS [12/2013 - ]