Cruise Main Indicator Light Circuit [12/2013 - 11/2016]: Description

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

When the dynamic radar cruise control system is turned on using the cruise control main switch (ON-OFF button), the cruise control indicator (vehicle-to-vehicle distance control mode) or cruise control indicator (constant speed control mode) illuminates. The driving support ECU assembly uses this and other indicators to indicate the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set speed) and fail-safe state via CAN communication.

HINT:

If the preceding vehicle in the same lane significantly decreases vehicle speed or another vehicle moves in front of this vehicle, adequate deceleration cannot be applied by the dynamic radar cruise control system and the vehicle-to-vehicle distance will become shorter. At this time, the system sounds the buzzer to warn the driver. The indicators for the dynamic radar cruise control system use CAN for communication. Therefore, if there are any indicator malfunctions, check for DTCs in the CAN communication system before troubleshooting this circuit.