Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL THERMOSTAT

Install a new gasket to the thermostat.

Install the thermostat to the water inlet housing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Jiggle Valve
*b	10°

HINT:

The jiggle valve may be set within 10° on either side of the prescribed position.

INSTALL WATER INLET
1. Install the water inlet with the 2 nuts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
CONNECT NO. 2 RADIATOR HOSE
Refer to PROCEDURE - Step 44
INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
INSTALL V-RIBBED BELT
Refer to INSTALLATION [12/2013 - 11/2016]
ADD ENGINE COOLANT
See step 3
INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 84