Installation [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL RADIATOR ASSEMBLY
- Engage the 3 guides.
- Engage the 3 claws to install the fan shroud assembly to the radiator assembly.NOTE:
Do not damage the radiator assembly when installing the fan shroud assembly.
- Install the 2 radiator supports to the radiator assembly.
- Install the 2 lower radiator supports to the vehicle body.
- Install the radiator assembly with the fan shroud assembly to the 2 lower radiator supports.
- CONNECT OUTLET NO. 1 OIL COOLER HOSE
- Connect the outlet No. 1 oil cooler hose and slide the clip to secure it.
- CONNECT INLET NO. 1 OIL COOLER HOSE
- Connect the inlet No. 1 oil cooler hose and slide the clip to secure it.
- Engage the clamp to connect the inlet No. 1 oil cooler hose.
- CONNECT RADIATOR RESERVE TANK HOSE
See step 7
- CONNECT NO. 2 RADIATOR HOSE
- Connect the No. 2 radiator hose and slide the clip to secure it.
- CONNECT NO. 1 RADIATOR HOSE
See step 8
- INSTALL COOLER CONDENSER ASSEMBLY
Refer to INSTALLATION [12/2013 - 11/2016]
- ADD ENGINE COOLANT
See step 3
- ADJUST AUTOMATIC TRANSAXLE FLUID
for U660E: Refer to ADJUSTMENT [12/2013 - 11/2016]
for U660F: Refer to ADJUSTMENT [12/2013 - 11/2016]
- INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1
- INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 96
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 84