LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission (U660F) - Service Information (1 Of 2)) >> Transmission Wire >> Installation [12/2013 - 11/2016] >> Procedure

Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION WIRE 
    1. Coat the O-ring with ATF.
      GTY438318Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 O-ring
    2. Coat the bolt with ATF.
    3. Install the transmission wire and lock plate to the transmission valve body assembly with the bolt.

      Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf) 

    4. Install the transmission wire clamp.
    5. Connect the shift solenoid valve SL connector.
    6. Connect the shift solenoid valve SLT connector.
    7. Connect the shift solenoid valve SLU connector.
    8. Connect the shift solenoid valve SL2 connector.
    9. Connect the shift solenoid valve SL1 connector.
    10. Connect the shift solenoid valve SL3 connector.
    11. Connect the shift solenoid valve SL4 connector.
    12. Connect the oil pressure switch assembly connector.
    13. Connect the revolution sensor connector.
  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 

    Refer to INSTALLATION [12/2013 - 11/2016] 

scientia non olet · About LEMON Manuals