LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Automatic Transmission (U660F) - Diagnostic Codes & Circuit Tests) >> Automatic Transaxle System >> DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low Input; DTC P0713: Transmission Fluid Temperature Sensor "A" Circuit High Input [12/2013 - 11/2016] >> Description

DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low Input; DTC P0713: Transmission Fluid Temperature Sensor "A" Circuit High Input [12/2013 - 11/2016]: Description

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

The Automatic Transmission Fluid (ATF) temperature sensor converts the fluid temperature into a resistance value for use by the TCM.

Fig 1: Automatic Transmission Fluid (ATF) Temperature Sensor Graph
GTY451561Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

The TCM applies a voltage to the temperature sensor through terminal THO1 of the TCM.

The sensor resistance changes with the ATF temperature. As the temperature becomes higher, the sensor resistance decreases.

One terminal of the sensor is grounded so that the sensor resistance decreases and the voltage goes down as the temperature becomes higher.

The TCM calculates the fluid temperature based on the voltage signal.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0712 Transmission Fluid Temperature Sensor "A" Circuit Low Input ATF temperature sensor resistance is less than 79 Ω for 0.5 sec. or more (1-trip detection logic).
  • Short in ATF temperature sensor circuit
  • Transmission wire
  • ATF temperature sensor
  • TCM
Comes on DTC stored
P0713 Transmission Fluid Temperature Sensor "A" Circuit High Input ATF temperature sensor resistance is more than 156 kΩ for 0.5 seconds or more, and either of the following conditions is met (1-trip detection logic):
  • Condition (A): 394 seconds or more have elapsed after the engine start when engine coolant temperature or intake air temperature is -29.375°C (-20.875°F) or less.
  • Condition (B): 10 seconds or more have elapsed after the engine start when engine coolant temperature and intake air temperature are more than -29.375°C (- 20.875°F).
  • Open in ATF temperature sensor circuit
  • Transmission wire
  • ATF temperature sensor
  • TCM
Comes on DTC stored