DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / ECT / Trouble Codes.
Powertrain > ECT > Trouble Codes
- Read the DTCs using the Techstream.
Result
Result Proceed to Only DTC P0711 is output A P0711 and other DTCs are output B HINT:
If any DTCs other than P0711 are output, perform troubleshooting for those DTCs first.
Result: 2
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2013 - 08/2014] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 11/2015] Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2015 - 11/2016]
Result: 1
A
See step 2
- CHECK TRANSMISSION FLUID LEVEL
- Check the transmission fluid level.
Refer to ADJUSTMENT [12/2013 - 11/2016]
OK
Automatic transmission fluid level is correct.
Result
Proceed to OK NG
Result: 1
OK
REPLACE ATF TEMPERATURE SENSOR. Refer to COMPONENTS [12/2013 - 11/2016]
Result: 2
NG
ADJUST FLUID LEVEL
- Check the transmission fluid level.