Installation [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)

Apply adhesive to 2 or 3 threads of the PCV valve (ventilation valve sub-assembly).

Adhesive

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

*a	Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Using a 19 mm deep socket wrench, install the PCV valve (ventilation valve sub-assembly) to the cylinder head cover LH sub-assembly.
Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)

NOTE:
Do not start the engine for at least 1 hour after installation.
Install the ventilation hose assembly to the PCV valve (ventilation valve sub-assembly) and slide the clip to secure it.

INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 84