LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Starting System (2GR-FE) (Service Information) (Except Hybrid)) >> Ignition Switch >> Inspection [12/2013 - 11/2016] >> Procedure

Inspection [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY 
    1. Check the resistance.
      GTY434069Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Ignition or Starter Switch Assembly)
      *b LOCK
      *c ACC
      *d ON
      *e START
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        Between all terminals LOCK 1 MΩ or higher
        5 (AM1) - 7 (ACC) ACC Below 1 Ω
        5 (AM1) - 7 (ACC) - 8 (IG1) ON Below 1 Ω
        3 (IG2) - 4 (AM2)
        5 (AM1) - 6 (ST1) - 8 (IG1) START Below 1 Ω
        2 (ST2) - 3 (IG2) - 4 (AM2)

        If the result is not as specified, replace the ignition or starter switch assembly.

scientia non olet · About LEMON Manuals