DTC C1232: Acceleration Sensor Stuck Malfunction; DTC C1243: Acceleration Sensor Stuck Malfunction; DTC C1245: Acceleration Sensor Output Malfunction [11/2016 - ]: Procedure

1. Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.

   Refer to INSTALLATION [11/2016 - ]

   OK

   The sensor is tightened to the specified torque.

   The sensor is not installed in a tilted position.

   NOTE:

   Check the yaw rate and acceleration sensor signal after replacement.

   Refer to TEST MODE PROCEDURE [11/2016 - ]

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

   Refer to PROBLEM SYMPTOMS TABLE [11/2016 - ]

Result:

OK 

REPLACE AIRBAG SENSOR ASSEMBLY. 

Refer to REMOVAL [12/2013 - ]

Result:

NG 

INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY. 

Refer to INSTALLATION [11/2016 - ]