Removal [12/2013 - ]: Procedure

See step  2

1. w/o Mudguard:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 3 screws.
   2. Remove the 4 clips.
2. w/ Mudguard:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 2 screws.
   2. Remove the 4 clips.
3. While pulling the rear bumper assembly, insert a finger between the rear bumper side seal LH and rear bumper assembly and disengage the 4 claws by pushing the area shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Quarter Panel Wheel Opening Moulding	*2	Rear Bumper Assembly
   *3	Rear Bumper Side Seal	-	-
   *a	Push	-	-

   NOTE:

   To avoid damaging the claws, do not forcibly pull the quarter panel wheel opening moulding.

   HINT: 

   Disengage the claws in the order shown in the illustration.

4. Disengage the 4 clips to remove the quarter panel wheel opening moulding.