Inspection [12/2013 - ]: Procedure
- INSPECT OUTER MIRROR HEATER SWITCH ASSEMBLY
*a Component without harness connected
(Outer Mirror Heater Switch Assembly)Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 4 Outer mirror heater switch assembly on Below 1 Ω 1 - 4 Outer mirror heater switch assembly off 10 kΩ or higher If the result is not as specified, replace the outer mirror heater switch assembly.
- Check that the indicator light illuminates.
*a Indicator Light *b Illumination *c Component without harness connected
(Outer Mirror Heater Switch Assembly)OK
Tester Connection Specified Condition Battery positive (+) → 3
Battery negative (-) → 2Outer mirror heater switch assembly indicator illuminates If the result is not as specified, replace the outer mirror heater switch assembly.
- Check that the illumination illuminates.
OK
Tester Connection Specified Condition Battery positive (+) → 1
Battery negative (-) → 5Outer mirror heater switch assembly illumination illuminates If the result is not as specified, replace the outer mirror heater switch assembly.