Inspection [12/2013 - ]: Procedure
- INSPECT GLASS HATCH OPENER SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Glass Hatch Opener Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Glass hatch opener switch assembly pushed Below 1 Ω 1 - 2 Glass hatch opener switch assembly not pushed 10 kΩ or higher If the result is not as specified, replace the glass hatch opener switch assembly.
- Measure the resistance according to the value(s) in the table below.