Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
CASE 1
| All of the following conditions are met | - |
| Battery voltage | 8 V or higher |
| Ignition switch | Off |
| CPU clock elapsed time | 1.96608 seconds or more |
CASE 2
| All of the following conditions are met | - |
| Internal engine off timer (elapsed time from engine stop) | 10 minutes or more, and less than 30 minutes |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | Off |
CASE 3
| All of the following conditions are met | - |
| Internal engine off timer (elapsed time from engine stop) | 40 minutes or more |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | Off |