DTC P060D: Internal Control Module Accelerator Pedal Position Performance [12/2013 - 11/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - 11/2016]

   Powertrain > Engine > Clear DTCs 

5. Turn the Techstream off.
6. Turn the ignition switch off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the ignition switch to ON.
12. Turn the Techstream on.
13. Wait for 16 seconds or more.
14. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
15. Read the DTCs.

    Powertrain > Engine > Trouble Codes 

    Result

    Result	Proceed to
    DTCs are not output	A
    DTC P060D is output	B

Result: 

A 

Refer to  CHECK FOR INTERMITTENT PROBLEMS [12/2013 - ] 

Result: 

B 

REPLACE ECM. Refer to  REMOVAL [12/2013 - ]