LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Transfer Case (Service Information) (Except Hybrid)) >> Transfer Oil >> Replacement [12/2013 - ] >> Procedure

Replacement [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN TRANSFER OIL 
    1. Remove the No. 1 transfer case plug and gasket from the transfer assembly.
      GTY428009Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the transfer drain plug and gasket and drain the transfer oil.
      GTY428008Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install a new gasket and the transfer drain plug.

      Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

  2. ADD TRANSFER OIL 
    1. Add transfer oil until the oil level is between 0 and 5 mm (0 and 0.197 in.) from the bottom lip of the case plug hole.
      NOTE:
      • When adding transfer oil, make sure that the vehicle is level.
      • Add transfer oil a little at a time, waiting several minutes between each addition of transfer oil.
      • After adding transfer oil, drive the vehicle and recheck the oil level.
      GTY369781Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a 0 to 5.0 mm (0 to 0.197 in.)

      Oil Type

      Toyota Genuine Differential gear oil LT API GL-5 or equivalent

      Viscosity

      SAE 75W-85

      Standard Capacity

      0.8 liters (0.8 US qts, 0.7 Imp.qts)

    2. After waiting for approximately 5 minutes, recheck the oil level.
    3. Install a new gasket and the No. 1 transfer case plug to the transfer assembly.

      Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

scientia non olet · About LEMON Manuals