DTC P0630: VIN Not Programmed or Mismatch - ECM/PCM [11/2016 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Powertrain > Engine and ECT > Trouble Codes
NOTE:If P0630 is output, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.
Result
Result Proceed to DTC P0630 is output A DTC P0630 and other DTCs are output B
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2016 - 10/2017] or DIAGNOSTIC TROUBLE CODE CHART [10/2017 - ]
Result:
A
See step 2
- INPUT VIN
- Input the VIN.
Refer to REGISTRATION [11/2016 - ]
- Input the VIN.