DTC P0013: Camshaft Position "B" Actuator Circuit / Open (Bank 1); DTC P0023: Camshaft Position "B" Actuator Circuit / Open (Bank 2) [11/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTC after recording the freeze frame data and DTC.

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the power switch off and wait for at least 30 seconds.
6. Turn the power switch on (IG) and wait 5 seconds or more.
7. Turn the Techstream on.
8. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
9. Read the DTCs.

   Powertrain > Engine and ECT > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0013 or P0023 is output	A
   DTCs are not output	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [11/2016 - ] 

Result: 

A 

See step  2

1. Inspect the cam timing oil control solenoid assembly (for exhaust camshaft).

   Refer to INSPECTION [11/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (FOR EXHAUST CAMSHAFT). Refer to  REMOVAL [11/2016 - ] 

Result: 

OK 

See step  3

1. Disconnect the cam timing oil control solenoid assembly (for exhaust camshaft) connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value (s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C75-1 - C1-33 (OE1+)	Always	Below 1 Ω
   C75-2 - C1-3 (OE1-)	Always	Below 1 Ω
   C74-1 - C1-32 (OE2+)	Always	Below 1 Ω
   C74-2 - C1-2 (OE2-)	Always	Below 1 Ω
   C75-1 or C1-33 (OE1+) - Body ground and other terminals	Always	10 kΩ or higher
   C75-2 or C1-3 (OE1-) - Body ground and other terminals	Always	10 kΩ or higher
   C74-1 or C1-32 (OE2+) - Body ground and other terminals	Always	10 kΩ or higher
   C74-2 or C1-2 (OE2-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [11/2016 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR