Installation [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Refer to INITIALIZATION [12/2013 - 11/2016]
- Install the 6 spark plugs to the cylinder head sub-assembly.
Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
NOTE:If a spark plug has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Install the 6 spark plugs to the cylinder head sub-assembly.
- INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Refer to INITIALIZATION [12/2013 - 11/2016]
- Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly with the 6 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
- Connect the 6 ignition coil assembly connectors.
- Engage the 2 wire harness clamps.
- Install the 6 ignition coil assemblies to the cylinder head cover sub-assembly with the 6 bolts.
- INSTALL INTAKE AIR SURGE TANK ASSEMBLY
Refer to INSTALLATION [12/2013 - 11/2016]
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing a spark plug or ignition coil assembly.
Refer to INITIALIZATION [12/2013 - 11/2016]
- Perform "Inspection After Repair" after replacing a spark plug or ignition coil assembly.