DTC P060A: Internal Control Module Monitoring Processor Performance [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- READ OUTPUT DTC (DTC P060A)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [12/2013 - 11/2016]
Powertrain > Engine > Clear DTCs
- Turn the Techstream off.
- Turn the ignition switch off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Wait for 16 seconds or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result Proceed to DTCs are not output A DTC P060A is output B
Result:
A
CHECK FOR INTERMITTENT PROBLEMS.
Refer to CHECK FOR INTERMITTENT PROBLEMS [12/2013 - 11/2016]
Result:
B
REPLACE ECM. Refer to REMOVAL [12/2013 - 11/2016]