LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Automatic Transmission (U660E) - Service Information (1 Of 2)) >> Shift Lever >> On-Vehicle Inspection [12/2013 - 11/2016] >> Procedure

On-Vehicle Inspection [12/2013 - 11/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Highlander, 2015 Toyota Highlander, and 2014 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT SHIFT LEVER POSITION 
    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, check that the shift lever moves smoothly and correctly into position.
    2. Start the engine and check that the vehicle moves forward when the shift lever is moved from N to D and moves rearward when the shift lever is moved to R.

      If the operation is not as specified, inspect the park/neutral position switch assembly or adjust the transmission control cable assembly.

  2. INSPECT SHIFT LOCK OPERATION 
    1. Move the shift lever to P.
    2. Turn the ignition switch off.
    3. Check that the shift lever cannot be moved from P to any other position.
    4. Turn the ignition switch to ON, depress the brake pedal, and check that the shift lever can be moved from P to any other position.

      If the operation is not as specified, inspect the transmission floor shift assembly.

      Refer to INSPECTION [12/2013 - 11/2016] 

  3. INSPECT SHIFT LOCK RELEASE BUTTON OPERATION 
    1. Turn the ignition switch off.
    2. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the shift lever cap from the transmission floor shift assembly.
      NOTE:

      Be careful not to damage the shift lever cap and transmission floor shift assembly.

    3. When moving the shift lever with the shift lock release button pressed, check that the shift lever can be moved from P to any other position.

      If the operation is not as specified, inspect the transmission floor shift assembly.

      Refer to INSPECTION [12/2013 - 11/2016] 

  4. INSPECT KEY INTERLOCK OPERATION (w/o Smart Key System) 
    1. Turn the ignition switch to ON.
    2. Depress the brake pedal and move the shift lever to any position other than P.
    3. Check that the ignition key cannot be turned to LOCK.
    4. Move the shift lever to P, turn the ignition key to LOCK and check that the ignition key can be removed.

      If the operation is not as specified, inspect the transmission floor shift assembly.

scientia non olet · About LEMON Manuals