Typical Enabling Conditions
ALL
| Monitor runs whenever the following DTCs are not stored | None |
COLD START MONITOR
| All of the following conditions are met | - |
| Battery voltage | 10.5 V or higher |
| Time after engine start | 1 second or more |
| Engine coolant temperature at engine start | Less than 60°C (140°F) |
| Soak time | 0 second or more |
| Accumulated mass air flow (w/ stop and start system) | 6088 g or more |
| Accumulated mass air flow (w/o stop and start system) | 8117 g or more |
| Engine | Running |
| Fuel cut | Off |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Engine coolant temperature sensor circuit fail (P0117, P0118) | Not detected |
| Difference between engine coolant temperature at engine start and intake air temperature (for mass air flow meter sub-assembly) | Less than 40°C (72°F) |
SOAK MONITOR
| All of the following conditions are met | - |
| Battery voltage | 10.5 V or higher |
| Last trip condition | Engine running |
| Soak time | 5 hours or more |
| Either of the following conditions is met | 1 or 2 |
| 1. Engine coolant temperature | 60°C (140°F) or higher |
| 2. Accumulated mass air flow (w/ stop and start system) | 12176 g or more |
| 2. Accumulated mass air flow (w/o stop and start system) | 16234 g or more |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Engine coolant temperature sensor circuit fail (P0117, P0118) | Not detected |
| Soak timer fail (P2610) | Not detected |