DTC B222B: PBD Touch Sensor RH Circuit [12/2013 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - ]

   Body Electrical > Back Door > Clear DTCs 

2. Check for DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - ]

   Body Electrical > Back Door > Trouble Codes 

   Result

   Result	Proceed to
   DTC B222B is not output	A
   DTC B222B is output	B

Result:  1

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - 11/2016]  Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2016 - ] 

Result:  2

B 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Back Door / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Back Door > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   PBD Touch Sensor (Right)	Power back door sensor assembly RH signal	ON, OFF or Open	ON: Power back door sensor assembly RH pressed OFF: Power back door sensor assembly RH not pressed Open: Power back door sensor assembly RH circuit open	-

   Body Electrical > Back Door > Data List 

   Tester Display
   PBD Touch Sensor (Right)

   Result

   Result	Proceed to
   On the Techstream screen, ON or OFF is displayed accordingly	A
   On the Techstream screen, ON or OFF is not displayed accordingly, or Open is displayed for power back door sensor assembly RH	B

Result:  1

A 

REPLACE MULTIPLEX NETWORK DOOR ECU. Refer to  REMOVAL [12/2013 - ] 

Result:  2

B 

See step  3

1. Remove the power back door sensor assembly RH.

   Refer to REMOVAL [12/2013 - ]

2. Inspect the power back door sensor assembly RH.

   Refer to INSPECTION [12/2013 - ]

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE POWER BACK DOOR SENSOR ASSEMBLY RH. Refer to  REMOVAL [12/2013 - ] 

Result:  1

OK 

See step  4

1. Disconnect the X6 multiplex network door ECU connector.
2. Disconnect the X24 power back door sensor assembly RH connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   X6-16 (OSR) - X24-1 (OSR)	Always	Below 1 Ω
   X6-17 (OSE) - X24-2 (OSRE)	Always	Below 1 Ω
   X6-16 (OSR) or X24-1 (OSR) - Body ground	Always	10 kΩ or higher
   X6-17 (OSE) or X24-2 (OSRE) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE MULTIPLEX NETWORK DOOR ECU. Refer to  REMOVAL [12/2013 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR