LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio / Video System - Diagnostic Codes & Symptom Tests - (Except Hybrid) >> Audio And Visual System >> DTC B15F7: Certification ECU Vehicle Information Reading/Writing Process Malfunction [12/2013 - ] >> Procedure

DTC B15F7: Certification ECU Vehicle Information Reading/Writing Process Malfunction [12/2013 - ]: Procedure

  1. CHECK CAN COMMUNICATION SYSTEM 
    1. Use the Techstream to check if the CAN communication system is functioning normally.

      Refer to DIAGNOSIS SYSTEM [12/2013 - 11/2016] Refer to DIAGNOSIS SYSTEM [11/2016 - ]

      OK

      CAN communication DTCs are not output.

      Result

      Proceed to
      OK
      NG

    Result:  2

    NG 

    GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - 11/2016]  Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2016 - ] 

    Result:  3

    OK 

    See step  2

  2. CHECK SMART KEY SYSTEM 
    1. Check if the smart key system is malfunctioning.

      for Entry Function: Refer to OPERATION CHECK [12/2013 - ]

      for Start Function: Refer to OPERATION CHECK [12/2013 - 11/2016] Refer to OPERATION CHECK [11/2016 - ]

      HINT: 

      Customization may not be possible depending on the malfunction in the smart key system.

      OK

      No malfunctions are present in the smart key system.

      Result

      Proceed to
      OK
      NG

    Result:  2

    NG 

    GO TO SMART KEY SYSTEM 

    for Entry Function: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - ]

    for Start Function: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - ]

    Result:  1

    OK 

    See step  3

  3. CHECK CUSTOMIZE ITEMS 
    1. Make a note of the customizable items for the certification ECU related system.

      HINT: 

      The items shown as customizable via the audio and visual system vehicle customization screen can also be changed using the Techstream. In the following step, the Techstream will be used.

      1. To match-up the items on the audio and visual system vehicle customization screen with the items on the Techstream, check the customize parameters list for the smart key system related items that can be customized via the audio and visual system vehicle customization screen.

        for Entry Function: Refer to CUSTOMIZE PARAMETERS [12/2013 - ]

        for Start Function: Refer to CUSTOMIZE PARAMETERS [12/2013 - ]

    2. Using the Techstream, confirm that it is possible to change the settings of the customize parameters that are available for customization via the audio and visual system vehicle customization screen.

      OK

      The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the Techstream.

      Result

      Proceed to
      OK
      NG

    Result:  1

    OK 

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [12/2013 - ] 

    Result:  2

    NG 

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY). Refer to  REMOVAL [12/2013 - ]