Reverse Signal Circuit [12/2013 - 11/2016]: Procedure

1. Move the shift lever to R and check if the back-up lights come on.

   OK

   The back-up lights come on.

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

GO TO LIGHTING SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - ] 

Result:  1

OK 

See step  2

1. Disconnect the F71 radio and display receiver assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F71-2 (REV) - Body ground	Ignition switch ON Shift lever in R	11 to 14 V
   F71-2 (REV) - Body ground	Ignition switch ON Shift lever in any position other than R	Below 1 V

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [12/2013 - 11/2015]  Refer to  PROBLEM SYMPTOMS TABLE [11/2015 - 11/2016] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR