Entire Combination Meter does not Operate [06/2018 - 09/2022]: Procedure

1. Disconnect the I4 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I4-19 (EP) - Body ground	Always	Below 1 Ω
   I4-23 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   I4-38 (IG+) - Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	11 to 14 V
   I4-22 (B) - Body ground	Always	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [06/2018 - 01/2019]  , or refer to  REMOVAL [01/2019 - 03/2019]  , or refer to  REMOVAL [03/2019 - 09/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR