LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> 86 Base, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostic Codes & Symptom Tests >> Meter / Gauge System >> On-Vehicle Inspection [06/2016 - 03/2017] >> Procedure

On-Vehicle Inspection [06/2016 - 03/2017]: Procedure

  1. INSPECT SPEEDOMETER 
    1. Check the operation.
      1. Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.
        INDICATOR TYPE: KM/H

        Chassis Dynamometer Indication (km/h) Acceptable Range (km/h)
        20 19.3 to 22.7
        40 39.1 to 42.9
        60 58.8 to 63.2
        80 78.8 to 83.2
        100 98.8 to 103.2
        120 118.8 to 123.2
        140 138.8 to 143.2
        160 158.8 to 163.2
        180 178.8 to 183.2
        200 198.8 to 203.2
        220 218.8 to 223.2
        240 238.8 to 243.2
        INDICATOR TYPE: MPH

        Chassis Dynamometer Indication (mph) Acceptable Range (mph)
        20 19.4 to 21.8
        40 39.3 to 41.9
        60 59.3 to 61.9
        80 79.3 to 81.9
        100 99.3 to 101.9
        120 119.3 to 121.9
        140 139.3 to 141.9
        NOTE:

        Tire wear, over inflation, or under inflation will cause errors.

      2. Check the deviation from the acceptable range of the speedometer indication.

        Reference

        Less than 0.5 km/h (0.3 mph)

        HINT: 

        If the indication is not as specified, go to the problem symptoms table (Refer to PROBLEM SYMPTOMS TABLE [06/2016 - 03/2017] ).

  2. INSPECT TACHOMETER 
    1. Connect a tune-up tachometer, and start the engine.
    2. Compare the test results with the tachometer indications.
      Tune-up Tachometer Indication (RPM) Acceptable Range (RPM)
      1000 933 to 1067
      2000 1923 to 2077
      3000 2913 to 3088
      4000 3913 to 4088
      5000 4913 to 5088
      6000 5913 to 6088
      7000 6913 to 7088
      8000 7913 to 8088

      HINT: 

      If the indication is not as specified, go to the Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [06/2016 - 03/2017] ).

  3. INSPECT INDICATOR AND WARNING LIGHTS 
    1. Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON.

      OK

      Warning or Indicator Light Specified Condition
      Low Fuel Warning or indicator light comes on for about 2 seconds after turning the ignition switch to ON.
      A/T Oil Temperature* Warning or indicator light comes on for about 2 or 3 seconds after turning the ignition switch to ON.
      TPMS Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON.
      BRAKE
      TRAC OFF
      VSC OFF
      TRACK
      SRS Airbag Warning light comes on for about 6 seconds after turning the ignition switch to ON.
      Charge The light goes off right after the engine starts.
      Oil Pressure
      MIL (Check engine warning light)
      EPS
      Slip The light goes off 3 minutes after starting the engine.
      ABS
      • *: for Automatic Transmission System