DTC C2176-76: Receiver Error [12/2012 - ]: Procedure

CHECK DTC OUTPUT (C2176/76)
1. Clear the DTCs.
  Refer to DTC CHECK / CLEAR [12/2012 - ]
  
  Chassis > Tire Pressure Monitor > Clear DTCs
2. Turn the ignition switch off.
3. Turn the ignition switch to ON.
4. Check for DTCs.
  Refer to DTC CHECK / CLEAR [12/2012 - ]
  
  Chassis > Tire Pressure Monitor > Trouble Codes
  
  OK
  
  DTC C2176/76 is not output.
Result:

OK

USE SIMULATION METHOD TO CHECK: HOW TO PROCEED WITH TROUBLESHOOTING [12/2012 - 11/2013] , HOW TO PROCEED WITH TROUBLESHOOTING [11/2013 - 10/2015] , HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - 08/2016] , HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 08/2017] , HOW TO PROCEED WITH TROUBLESHOOTING [08/2017 - ]

Result:

NG

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER: REMOVAL [12/2012 - ]