DTC C2111-11-C2115-15; Transmitter ID1 Operation Stop [12/2012 - ]: Procedure

PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS

Set the tire pressure to the specified value.
Refer to INSPECTION [12/2012 - 11/2013] , or refer to INSPECTION [11/2013 - ]
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

Check the values by referring to the table below.

Chassis > Tire Pressure Monitor > Data List

Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
ID 1 Tire Inflation Pressure	ID1 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm² , 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm² , 56 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*
ID 2 Tire Inflation Pressure	ID2 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm² , 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm² , 56 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*
ID 3 Tire Inflation Pressure	ID3 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm² , 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm² , 56 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*
ID 4 Tire Inflation Pressure	ID4 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm² , 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm² , 56 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.*
ID 5 Tire Inflation Pressure	ID5 tire inflation pressure	min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm² , 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm² , 0 psi) max.: Absolute pressure (abs) / 488.72 kPa (4.9 kgf/cm² , 70 psi), Relative pressure (Gauge) / 388.72kPa (3.9 kgf/cm² , 56 psi)	Actual tire inflation pressure	If N/A is displayed, data has not been received.* w/ Full Size Spare Tire

HINT:

*: It may take a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24 (C2125/25: w/ Full Size Spare Tire).

Refer to DTC C2121/21: No Signal from Transmitter ID1; DTC C2122/22: No Signal from Transmitter ID2; DTC C2123/23: No Signal from Transmitter ID3; DTC C2124/24: No Signal from Transmitter ID4; DTC C2125/25: No Signal from Transmitter ID5; DTC C2181/81: Transmitter ID1 not Received (Test Mode DTC); DTC C2182/82: Transmitter ID2 not Received (Test Mode DTC); DTC C2183/83: Transmitter ID3 not Received (Test Mode DTC); DTC C2184/84: Transmitter ID4 not Received (Test Mode DTC); DTC C2185/85: Transmitter ID5 not Received (Test Mode DTC) [12/2012 - ]

Chassis > Tire Pressure Monitor > Data List

Tester Display
ID 1 Tire Inflation Pressure
ID 2 Tire Inflation Pressure
ID 3 Tire Inflation Pressure
ID 4 Tire Inflation Pressure
ID 5 Tire Inflation Pressure

Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm² , 5.8 psi) within 30 seconds.
1. Check that each tire pressure data displayed on the Techstream has changed.
  OK
  
  Each tire pressure data displayed on the Techstream will change to the value of the tire pressure.
  NOTE:
  - It may take a few minutes to display the updated tire pressure data.
  - When the "ID Tire Inflation Pressure" data has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the data.
2. After confirming that all of the tire pressure data displayed on the Techstream has changed, set the tire pressure to the appropriate specified values.
  HINT:
  
  If the tire pressure data displayed on the Techstream has not changed after rechecking, inspect for another problem.
  
  Refer to DTC C2121/21: No Signal from Transmitter ID1; DTC C2122/22: No Signal from Transmitter ID2; DTC C2123/23: No Signal from Transmitter ID3; DTC C2124/24: No Signal from Transmitter ID4; DTC C2125/25: No Signal from Transmitter ID5; DTC C2181/81: Transmitter ID1 not Received (Test Mode DTC); DTC C2182/82: Transmitter ID2 not Received (Test Mode DTC); DTC C2183/83: Transmitter ID3 not Received (Test Mode DTC); DTC C2184/84: Transmitter ID4 not Received (Test Mode DTC); DTC C2185/85: Transmitter ID5 not Received (Test Mode DTC) [12/2012 - ]

Result:

END

Result:

GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE: DTC C2121/21: No Signal from Transmitter ID1; DTC C2122/22: No Signal from Transmitter ID2; DTC C2123/23: No Signal from Transmitter ID3; DTC C2124/24: No Signal from Transmitter ID4; DTC C2125/25: No Signal from Transmitter ID5; DTC C2181/81: Transmitter ID1 not Received (Test Mode DTC); DTC C2182/82: Transmitter ID2 not Received (Test Mode DTC); DTC C2183/83: Transmitter ID3 not Received (Test Mode DTC); DTC C2184/84: Transmitter ID4 not Received (Test Mode DTC); DTC C2185/85: Transmitter ID5 not Received (Test Mode DTC) [12/2012 - ]