Inspection [08/2016 - ]: Procedure
- INSPECT TELLTALE LIGHT ASSEMBLY (SEAT BELT WARNING LIGHT)
- Apply battery voltage to the connector according to the table below.
OK
Battery Connection Result Battery positive (+) - Terminal 9 (LAPB)
Battery negative (-) - Terminal 22 (RLID)Indicator A comes on Battery positive (+) - Terminal 9 (LAPB)
Battery negative (-) - Terminal 23 (RCID)Indicator B comes on Battery positive (+) - Terminal 9 (LAPB)
Battery negative (-) - Terminal 24 (RRID)Indicator C comes on *a Indicator A *b Indicator B *c Indicator C *d Component without harness connected
(Telltale Light Assembly(Seat Belt Warning Light))If the result is not as specified, replace the telltale light assembly (seat belt warning light).
- Apply battery voltage to the connector according to the table below.